ADET OLARAK SATILMAKTADIR !BUS TYPE UNIVERSAL SPEAKER CONNECTORS
Our Bus type Universal Speaker Connector (short named: Bus Connector) is a high quality modular solder style loudspeaker cable termination system universally suited for all our loudspeaker cable and wire types.
Because a connector must handle current, our design is made for this job.
All parts are heavy 24 carat gold plated so oxidation is almost impossible and the contact quality is maintained over a long period of use.
In short, our versatile Bus Connector provides a reliable and durable high quality connection to your amplifier and loudspeaker binding posts. For optimal contact care we recommend our The SOLUTION contact fluid.
Our Bus Connector consists of the following parts:
The connector base:
Consists of a fully gold plated connector barrel with "van den Hul” brand engraving.
At the cable entry side it accommodates the stripped conductor end in a separate solder bucket.
At the terminal side the barrel is threaded to receive the modular screw-in terminal.
The connector base is available in various cable entrance diameters:
3.0 mm. Ø: For cables with up to 3.0 mm. conductor diameter.
4.0 mm. Ø: For cables with up to 4.0 mm. conductor diameter.
5.0 mm. Ø: For cables with up to 5.0 mm. conductor diameter.
6.5 mm. Ø: For cables with up to 6.5 mm. conductor diameter.
8.0 mm. Ø: For cables with up to 8.0 mm. conductor diameter.
10.0 mm. Ø: For cables with up to 10.0 mm. conductor diameter.
The screw-in terminal:
Fully gold plated; The threaded screw-in terminal is to be screwed into the connector base part.
The large thread surface and tight fit provide a perfect electrical and mechanical contact between both parts.
The screw-in terminal is available in two versions:
Banana Tip (*)
With "van den Hul” brand engraving
Standard 4 mm. type
With caged spring contact section; Providing a reliable, fully mating connection with minimal contact resistance.
*: The spade and banana terminals are WBT binding post fitting.
The heat-shrinkable insulation sleeve:
Provides encapsulation, environmental protection, strain relief and electrical insulation.
Available in Red or Blue with "van den Hul” brand printing.
Our Bus Connector is available:
A piece in either spade or banana version. In cable entrance diameter (3.0, 4.0, 5.0, 6.5, 8.0 or 10.0 mm.) and including a red or blue insulation sleeve
As separate parts: -Connector base (body) in cable entrance diameter (3.0, 4.0, 5.0, 6.5, 8.0 or 10.0 mm.) -Screw-in terminal (head) in spade or banana version -Heat-shrinkable insulation sleeve in red or blue