Kingston HyperX Fury 2x8GB Bellek - HX318C10FWK2/16

  • Kingston HyperX Fury 2x8GB Bellek - HX318C10FWK2/16

Temel Özellikler

Kingston Hyperx 16gb Kit (2x8gb) Ddr3-1866mhz Bellek - Hx318c10fwk2/16 RAM
573,58 TL KDV
+ Kargo Bedeli: ₺2,95 SATIN AL

Ürün Kodu: 795548

Ürün Bilgisi

16GB (8GB 1G x 64-Bit x 2 pcs.)
DDR3-1866 CL10 240-Pin DIMM Kit
HyperX HX318C10FWK2/16 is a kit of two 1G x 64-bit (8GB)
DDR3-1866 CL10 SDRAM (Synchronous DRAM) 2Rx8 memory
modules, based on sixteen 512M x 8-bit DDR3 FBGA components
per module. Total kit capacity is 16GB. Each module kit
has been tested to run at DDR3-1866 at a low latency timing of
10-11-10 at 1.5V. Additional timing parameters are shown in
the PnP Timing Parameters section below. The JEDEC standard
electrical and mechanical specifications are as follows:
• DDR3-1866 CL10-11-10 @1.5V
• DDR3-1600 CL9-10-9 @1.5V
• DDR3-1333 CL8-9-8 @1.5V
CL(IDD) 10 cycles
Row Cycle Time (tRCmin) 44.75ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 32.125ns (min.)
Maximum Operating Power TBD W
(per module)
UL Rating 94 V - 0
Operating Temperature 0o C to 85o C
Storage Temperature -55o C to +100o C
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 933MHz fCK for 1866Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• Height 1.291” (32.80mm) w/heatsink, double sided

Ürün Yorumları

Taksit Planı

RAM Kategorisinin Çok Satan Ürünleri